by John Sawyer, Department of Agronomy
Tools are available that can aid decisions about applying supplemental nitrogen (N) when there have been losses of applied fertilizer or manure N. These can provide more site-specific information than estimating losses and can also provide N rate application guidance.
Late spring soil nitrate test
Details about this test can be found in ISU Extension publication Nitrogen Fertilizer Recommendations for Corn in Iowa, PM 1714. Soil samples are collected when corn is 6 to 12 inches tall, often in late May to early June. This year the corn growth is behind, soils have been cool, and with the current wet soils, some fields will be sampled later than normal. Soil conditions should allow the collection of good samples from the entire one-foot depth and with no excess water "leaking" from the sample bag. With the current wet conditions, this could be difficult. A large number of cores are needed, especially in fields with band-injected nitrogen (N). Test interpretations are adjusted when spring rainfall is well above normal. In fields where less than full rates of N were applied preplant, lower the critical concentration from 25 ppm to 20—22 ppm when rainfall from April 1 to time of sampling is more than 20 percent above normal. With full rates of N applied preplant (fall or early spring) or with manured soils, the suggested critical concentration is 15 ppm if May rainfall exceeds 5 inches. In these fields, if tests are between 16 and 20 ppm, consider a small N application. In situations where manure or full rates of N were applied, a suggestion is to limit additional N application to 60—90 lb N per acre, even if the test result is 10 ppm or less.
Corn plant nitrogen status
A method to determine the N status of corn plants is explained in ISU Extension publication Sensing Nitrogen Stress in Corn, PM 2026. The corn plant expresses N shortage through reduced leaf greenness and plant biomass, which can be seen as you look at corn plants and measured with sensors such as a chlorophyll meter, active canopy sensors or remote images. Measurements need to be compared with adequately fertilized (non-N limiting) reference areas in order to reduce bias due to different growing conditions, soils, hybrids or factors affecting corn plant color and growth other than N deficiency (like plant yellowing in response to wet soils or sulfur deficiency).
If you are concerned about N losses, then apply two or three supplemental N strips across fields or in targeted field areas and watch the corn. These will be the reference areas that can be compared with the rest of the field. When corn gets some size to it, around the V8—V10 growth stages, and you see differences in the color between the strips and the rest of the field, then additional N should be applied to the field or field areas showing deficiency. These applications should be made as quickly as possible in order for the corn to have the best chance to respond to the supplemental N.
Quantifying N deficiency stress and the amount of N to apply can be accomplished by monitoring the crop with a chlorophyll meter or active canopy sensors. Relative sensing values (readings from the field area of interest divided by readings from the reference area) give an indication of the severity of deficiency; that is, the lower the relative value the greater the N deficiency and the larger the N application rate needed.
Sensing the plant N status can aid in confirming suspected N-loss situations and need for supplemental N. This is especially helpful when corn has recovered from wet conditions, resumed good growth and is putting pressure on the available N supply in the soil. The later into the growing season sensing is conducted, the more it can indicate deficiencies and the better related to total crop N fertilization need. Small plants usually do not reflect potential N shortages because the amount of N taken up is small, and easily met by soil N or N fertilization. Therefore, corn plant sensing is more reliable with larger plants. Measurements from approximately V10 to VT stages should provide similar results. Suggested N rates to apply based on sensing can be obtained from ISU Extension publicationPM 2026 for the chlorophyll meter. For active canopy sensors, recent evaluation and research calibration for specific active sensors and relative indices can be found in the conference publication Quantifying Nitrogen Deficiency and Application Rate with Active Canopy Sensors, or refer to company provided guidelines based on their specific sensor operation and canopy index.
An advantage of plant N stress sensing or visual observation and comparison with reference areas, is the ability to monitor the crop multiple times as the season progresses to see if the N supply is adequate, remains adequate or N stress develops. Wet soils will cause corn to have poor coloration and rooting, and can also limit yield potential. Therefore, it is important to allow plants to recover fully from wet conditions before assessing the N status. Another advantage to plant N stress sensing is that plants integrate N supply across a period of time. Since mineralization of N from soil organic matter is an important source of N for crop growth, waiting to determine the N status allows the plant to respond to N accumulated in the soil from mineralization. Warm, moist soils with high organic matter levels can have considerable mineralization (even when flooded), and this source of N can help offset N losses. Plant sensing and comparison to reference areas is a way to determine this contribution, as well as nitrate located deeper in the soil profile.
John Sawyer is a professor of agronomy with research and extension responsibilities in soil fertility and nutrient management.
Links to this article are strongly encouraged, and this article may be republished without further permission if published as written and if credit is given to the author, Integrated Crop Management News, and Iowa State University Extension and Outreach. If this article is to be used in any other manner, permission from the author is required. This article was originally published on June 13, 2011. The information contained within may not be the most current and accurate depending on when it is accessed.