Estimating First Crop Alfalfa Harvest using PEAQ

May 9, 2024 9:30 AM
Blog Post

Estimating First Crop Alfalfa Harvest using PEAQ

Alfalfa growth and development is affected by many factors, including temperature, soil moisture, stand age and even cultivar. We have had a warmer and milder winter leading into spring, causing earlier alfalfa green-up and growth. This is a reminder that using calendar date to determine when to harvest the first crop of alfalfa may not be the best method. In order to accurately predict the optimal time for the first cutting, the University of Wisconsin developed the Predictive Equations for Alfalfa Quality (PEAQ) method.

PEAQ uses alfalfa height and maturity stage (vegetative, bud, or open flower) to estimate relative feed value (RFV). In general, it is recommended to harvest alfalfa at about 150 RFV for milking dairy herds and 125 RFV for heifers, stocker cattle, and lactating beef cattle. The RFV of first crop alfalfa can drop three to five RFV points per day after it reaches peak value. The steps on how to use the PEAQ method to determine when to make the first crop of alfalfa are listed below.

While PEAQ provides an estimate of RFV, adjustments need to be made for harvest loss. Even under the best harvest conditions, 10-20% of the forage dry matter can be lost at harvest. This amounts to approximately 15 RFV points for haylage and 25 RFV points for dry hay. Therefore, to end up with 150 RFV alfalfa, harvest the crop when PEAQ measurements estimate a RFV of 165 for a haylage harvest and 175 for a hay harvest. Additionally, consider weather forecasts and allowing for proper drying time when deciding when to harvest alfalfa.

Measuring the tallest alfalfa stem. Photo by Josh Michel, Iowa State University.

Photo 1. Measuring the tallest alfalfa stem. Photo by Josh Michel, Iowa State University

Steps for using PEAQ to determine when to harvest first crop alfalfa

Step 1. Choose a representative two square foot area in the field.

Step 2. Determine the stage of the most mature stem as defined in Table 1.

Step 3. Measure the tallest stem in the area (Photo 1). Measure the stem from the soil surface to the tip of the stem; not to the tip of the leaf. Straighten the stem for an accurate height measurement. Based on stem maturity and stem height, use Table 1 to estimate the RFV of standing alfalfa crop.

Step 4. Repeat steps 1-3 in five representative areas across the field.

Step 5. To estimate harvest quality, subtract 15-25 RFV units to account for harvest losses during the haylage or hay harvest process, respectively.

Step 6. Determine optimum harvest time using the PEAQ estimate, livestock forage quality needs, considerations of upcoming weather forecasts favorable for harvest and drying, and the general assumption that RFV drops three to five points per day.

Iowa State University Extension and Outreach maintains a PEAQ website that includes a fact sheet to explain how to use the PEAQ method to determine when to harvest first crop alfalfa. This website also includes postings of PEAQ values from alfalfa fields across Iowa that are monitored by Iowa State University Extension and Outreach staff. Following these reports is helpful in tracking alfalfa development, but remember that crop conditions vary field-by-field. Therefore, it is recommended to take PEAQ measurements in your own field for the best assessment of when to harvest alfalfa for the optimum forage quality for your operation.

PEAQ RFV Chart

Category: 
Authors: 

Joshua Michel Field Agronomist in NE Iowa

Joshua Michel joins ISU Extension and Outreach as a field agronomist after working at the Muscatine Island Research and Demonstration Farm. While at the farm he was responsible for coordinating corn and soybean field studies that included planting, harvesting, tillage and pest management. Mi...