Hayfield Lodging – Management Concerns and Guidelines

June 13, 2008
ICM News

By Stephen K. Barnhart, Department of Agronomy and Mark Hanna, Department of Agricultural and Biosystems Engineering  

Rain, wind, hail, and unavoidable harvest delays have led to lodged and flat hayfields across the state. This is not usually a concern in more normal seasons, but if it occurs, producers have to manage for and around it.  

A ‘bright side’ of delayed harvest is that the forage plants have longer to accumulate carbohydrate ‘stores’ and maintain plant vigor. 

Just because hay lodges, does not mean that it will ‘smother itself.’ New alfalfa and grass shoots that will become the second growth will emerge through the older, lodged first growth. However, harvesting this combined first and partial second growth will interrupt the development of the second growth and likely slow its eventual regrowth. So, there may be a slightly longer interval between your first and second cuts this year.

A delayed first harvest often shortens the number of harvests for the season – instead of a normal four cuts you may only get three this year. In addition, the sequence of the remaining harvests should be spaced to allow for a 4 to 5 week ‘fall rest’ during September and early October to maintain the vigor of the stand going into winter.

The mature plants will be of low nutritive quality, so should be sampled and tested for forage quality and for efficient ration balancing when feeding.

Leaf and stem diseases are favored in a high-humidity, lodged canopy.

Some producers who had a chance to cut hay between storms may not have been able to bale or chop it. Windrows left in place for a long period can lead to smothering of regrowth forage. If you have windrows that have been in place for days, try to turn or harvest them as soon as possible.

In some cases, the nutritive value has deteriorated to the point that the hay may not be worth the money and effort to bale or chop it for forage. Producers sometimes sacrifice this yield option and chop or shred the weathered hay back onto the field. If you resort to this, ensure that the chopped forage is uniformly spread.

The physical process of cutting lodged hay presents challenges. Whether you are using a sickle mower or a disc mower, some machine adjustments may be necessary for effective cutting.

  • Tip the cutter bar down.

  • Take some weight off the knife or disc platform to protect the knives using the lift assist springs.

  • Keep the cut height reasonably low to get down under mat of crop.

  • Use disc cutter knives with a twist to get a little more lift, and consider use of ‘crop lifters’ designed for the disc mower

  •  If the mower has a pick-up reel, bring the reel forward and increase the reel speed if adjustments are available. 

  • Consult your operator manual for proper adjustments.

Cutting in one direction against the lodge is an effective harvest management practice, but greatly slows harvest productivity. It may be more practical in the long run to cut as usual, leaving longer, partially-cut stems on half the passes in the field and get a better overall quality on the field as a whole. Timeliness may be more economically valuable than the appearance of the field.

Stephen K. Barnhart is a professor of agronomy with extension, teaching, and research responsibilities in forage production and management. Mark Hanna is an extension agricultural engineer in agricultural and biosystems engineering with responsibilities in field machinery.

Category: 

Links to this article are strongly encouraged, and this article may be republished without further permission if published as written and if credit is given to the author, Integrated Crop Management News, and Iowa State University Extension and Outreach. If this article is to be used in any other manner, permission from the author is required. This article was originally published on June 13, 2008. The information contained within may not be the most current and accurate depending on when it is accessed.

Tags: 
Author: