Repairing Flood-Damaged Farm Fields

July 30, 2024
ICM News

Farm fields that have been covered with flood waters may need structural (physical) repair before returning to full production. Flood debris, sand, silt, erosion, and loss of soil structure may all result as residual effects of flooding.

Before You Begin

Erosion caused by flooding may have removed soil cover over buried utilities such as gas, electric, and communication lines. At least two days before any excavation or deep tillage, contact your utility locator service to locate and mark underground utilities. Contact Iowa One Call at (800) 292-8989 or at www.iowaonecall.com. Directions and assistance can also be found on the Iowa State University Disaster Recovery website at www.extension.iastate.edu/disasterrecovery/.

Debris Removal

Flood waters will leave piles of plant debris and driftwood behind. Other items such as building materials, furniture, barrels and tanks, and assorted garbage may also be present. As soon as soil conditions allow, begin taking inventory where debris is located. Aerial or drone imagery could be a useful tool in locating and Flood damage in a farm field.identifying debris over large areas. Note any potentially hazardous items such as fuel tanks or unmarked containers. Household hazardous materials (HHM) should be separated and stored safely for proper disposal. For details, contact the Iowa Department of Natural Resources at www.iowadnr.gov/about-dnr/social-media-press-room/disaster-assistance. Forms and resources are available for disposal of orphan tanks and drums (fuel and propane tanks), private well testing, and Flood Plain assistance (1-866-849-0321).

Plant debris (free of other trash) that is less than 4 inches deep can likely be incorporated into the soil with tillage. Consider the additional nitrogen demand caused by decomposing plant debris in the soil. When plant debris is more than 4 inches thick, it may be necessary to spread it into a thinner layer before incorporating.

Residue too sizeable to incorporate may have to be removed and/or burned. In Iowa, flood debris including plant residue, trees, and building materials can be burned in farm fields as long as tires, asbestos, and asphalt shingles are removed. Iowa prohibits pushing flood debris back into rivers. For more information contact the Iowa Department of Natural Resources as listed above. When burning, keep safe separation distances and fire safety in mind, and allow adequate drying time before attempting to burn debris. Follow underground utility guidelines mentioned above before digging holes to bury ashes or debris.

Sand Removal

As with debris, flood waters may deposit large amounts of sand in farm fields. Sand drifts will likely be deepest near broken levees where water velocity decreased rapidly and may be several feet deep. Mapping the extent of sand deposits on a soil map or aerial photo can help determine appropriate movement and spreading strategies. Using a soil probe, tile probe, or any other slender rod may help quickly determine sand depth.

When sand deposits are thin, they may be successfully mixed into the soil with tillage equipment. Deeper deposits may require spreading or removal. Allowable sand depth for mixing into the soil depends on the underlying soil type and tillage method. Refer to the soil survey for your county to determine actual soil types (soil map units) in your fields. Or the USDA web soil survey website at https://websoilsurvey.nrcs.usda.gov/app/. These guidelines should be appropriate for most Iowa river bottom or river adjacent soils.

Sand less than 2 inches deep: Let normal field operations incorporate this sand.

Sand 2-8 inches deep: Incorporate sand into underlying soil with a chisel plow, moldboard plow, or other aggressive tillage tool. Depth and aggressiveness of tillage required will vary with the depth of sand and texture of the underlying soil. The goal is to achieve a modified soil that still has adequate water holding capacity in the root zone. Because the sand is likely in drifts, use a front-end loader to spread the piles to decrease the depths to 4 inches, and then till across the piles to twice the depth, several times. Flooded farm field.

For silty clay loam soils, tilling sand to a depth at least 1.5 times the original sand depth is recommended (e.g., use a 9-inch tillage depth for a 6-inch layer of sand). Sandy soils may require tillage to a depth of twice the sand depth or more for satisfactory results.

Sand 8-24 inches deep: If possible, spread this sand to areas with less than 4 inches of sand and treat as mentioned above. If the extent of the deep sand is too large to spread to less than 6 inches deep, treat the area as mentioned below.

Sand more than 24 inches deep: Evaluate the cost of moving the sand to waste or stockpile areas. Consider the relative costs of moving the sand and of abandoning the crop area. Note that sand may be moved to field border areas, but water quality rules prohibit pushing sand back into a river.

Before beginning tillage or sand moving efforts, carefully evaluate the moisture condition of the soils. Flooded soils can be slow to dewater and dry. Some areas of the field may need more time to dry before tillage or traffic. If heavy traffic (scrapers, trucks, etc.) is planned, try to limit the heavy traffic to controlled lanes which can be deep-tilled to repair compaction.

When the flood subsides, there is often a thin layer of clay over all the land, and when it dries out, it will crake and lift up at the edges. This layer needs to be tilled into the soil to restore the water movement of the soil below.

If a field included any wetlands or farmed wetland areas prior to flooding, talk to your local Natural Resources Conservation Service (NRCS) office prior to moving sand in that field. Regulations may require special provisions or protection for those wetland areas.

Deep tillage tools are available for inverting soils to depths deeper (4-5 feet) than reached by moldboard plows.

The cost and availability of this type of equipment may make sand removal more practical than extra deep tillage. The cost for custom tillage and other practices needed can be found in the Iowa State University Iowa Farm Custom Rate Survey. This survey is conducted yearly, and is available on the Iowa State University Ag Decision Maker website or at https://www.extension.iastate.edu/agdm/crops/html/a3-10.html. Prices for tillage types and operations vary with the typical prices ranging from $18-24 per acre for treatment in 2024.

Gully Repair

In areas where water velocity was higher, erosion may have occurred. Shallow erosion of less than one foot may be repaired with tillage on deep river bottom soils. Deeper erosion repair may require earth moving equipment. Be cautious about using debris sand to fill deep erosion channels unless adequate depth of quality soil can be placed over top of the sand fill. Again, water holding capacity of the finished soil is the primary concern.

In some cases, severely eroded areas may be too expensive to repair. Selective abandonment of small areas may be a more logical choice. Land easement program options may influence the economics of this choice.

Land Leveling

In some cases, the use of flood irrigation may require much more precise land leveling as part of the field repair. Refer to flood irrigation materials for advice on these situations.

Fertility and Soil Health

As mentioned, soil testing is critical for good management following the physical repair of flooded fields. Testing separately from areas with different amounts of sand incorporation may be appropriate to account for nutrient levels of the sand. Adding organic matter may be beneficial to soils where large amounts of sand are incorporated. Compost and manure are excellent sources of additional organic matter.

Consider grid sampling or sampling by soil map unit and area of greatest sand addition to identify specific areas of need. Refer to agronomic bulletins or your agronomist for specific fertility advice.

Soil microbiology can also change during and after flooding. Refer to the bulletin in this series on Flooded Soil Syndrome for discussion of this topic.

Compaction

Some people assume that the weight of flood waters can lead to soil compaction. The weight of the water itself does not lead to high soil pressures (5 feet of water equals 2.2 psi). The fact that soil pore space may be filled with water during flooding adds to the resistance of the soil to compaction. Even sand deposits, while denser than water (5 feet of sand equals 4.2 psi), do not cause high pressure on the soil. However, loss of soil structure may cause effects similar to soil compaction.

Prolonged exposure to water and wave action may destroy the soil structure (aggregation and soil porosity). Submerged soils may develop a layer of very dense consolidated silt that is resistant to water infiltration and plant root penetration. This effect is often visible in the bed of a dry pond or lake. While this is technically not the result of soil compaction, the effect can be similar. Given adequate drying conditions, this layer will likely dry, shrink, and crack. If the layer is only one or two inches thick, tillage and subsequent weathering and biological activity should return the soil structure in time. In severe cases, deep tillage and more time may be required.

Documentation

In cases where insurance or other assistance programs may provide financial reimbursement, it will be important to document restoration expenses. Keep receipts for all purchased materials, supplies, and services, as well as records of your own labor.

Resources

Repairing Flood Damaged Fields. Technical Notes, Agronomy #22. USDA Soil Conservation Service, November, 1993. http://efotg.sc.egov.usda.gov// references/public/IA/AgronomyTECHnote22.pdf

Soil Testing Following Flooding, Overland Flow of Waste Waters and other Freshwater Related Disasters. T.L. Provin, S.E. Feagley, J.L. Pitt, M.L. McFarland. Texas Cooperative Extension SCS-2008-07 http://varietytesting. tamu.edu/criticalinformation/Freshwater%20flooding%20 soil%20testing%20issues.pdf

Flooded Soil Syndrome. J. Sawyer, A. Mallarino, M. Al-Kaisi. Iowa State University
https://dr.lib.iastate.edu/entities/publication/72ce9b29-7669-47d3-bd4a-...

Iowa Department of Natural Resources Guide to Flood Clean up in Rural Areas
https://www.iowadnr.gov/Portals/idnr/uploads/files/disaster/FloodCleanup%20in%20Rural%20Areas.pdf

Iowa Department of Natural Resources Disaster Recovery – Flood https://www.iowadnr.gov/About-DNR/Social-Media-Press-Room/Disaster-Assis...

2024 Iowa Farm Custom Rate Survey
https://www.extension.iastate.edu/agdm/crops/pdf/a3-10.pdf

Previously published in September 2011 by Shawn Shouse, former agricultural engineer, Iowa State University Extension and Outreach in coordination with University of Nebraska Extension.

Revised in July 2024 by Michael Witt, Field Agronomist, Iowa State University Extension and Outreach and Kris Kohl, Agriculture Engineer, Iowa State University Extension and Outreach.

 

Category: 

Links to this article are strongly encouraged, and this article may be republished without further permission if published as written and if credit is given to the author, Integrated Crop Management News, and Iowa State University Extension and Outreach. If this article is to be used in any other manner, permission from the author is required. This article was originally published on July 30, 2024. The information contained within may not be the most current and accurate depending on when it is accessed.

Crops: 
Author: 

Michael Witt Field Agronomist in WC Iowa

Michael Witt is a field agronomist in west central Iowa for Iowa State University Extension and Outreach. Educational programs and learning opportunities are available for farmers, agribusinesses, certified crop advisors, agronomists, and farm managers. Areas of expertise include agronomic evalua...